Application Guide

PREPARATION
• Place the pre-taped film or several layers of old newspaper on the floor
• Tape off edges with low adhesion masking tape
• Repair rough surface by sanding using sand paper or sandpad
• Clean dirty areas and remove dust with a clean dry cloth
• Prime the wall / subtract if needed
• Prepare the Whiteboard Paint in amount sufficient for the area
NOTE : If ever you are applying on large surface, DO NOT pour too much paint at one time on the tray as it will dry in 50 mins.

APPLY
• Apply Candy Whiteboard Paint to surface
• One thin 1st coat at 4 mils to 5 mils.
• Saturate the roller and apply liberally
• For best result, work vertically from one side of the surface to the other in 1 meter increments
• Pay attention while painting and remove any debris as you go and make repairs immediately.
NOTE : DO NOT put too much paint on the roller as it may create dripping effect on the painted area.
If there is dripping effect after it is semi-dried, you can use a small fiber paint brush or existing roller slightly even out.

WAIT
• Wait for 2 hours to touch dry and then apply the 2nd coat of the Candy Whiteboard Paint to the surface
• One thin coat at 4 mils to 5 mils.
• Saturate the roller and apply liberally

COMPLETED
• Once completed the 2nd coat, please dispose the paint rollers, bucket, tray, gloves, plastic sheet, newspaper to designated places.
• You may turn on a fan at low speed to speed up the dryness of paint but do not blow directly to the painted area
• 4 days cure time when painted in area temperature of 25°C or above.
NOTE: DO NOT pour the paint to the drainage as it may cause congestion

Maintenance Guide

WRITING: Every marker is different from the shape to it’s ink. To provide you with the best Whiteboard surface experience we perform a series of tests on every Whiteboard marker available in Asia and USA. As for result we highly recommend the Refillable Markers www.refillablemarker.com by E-Stationery Supplies, Pilot Vboard Marker. Otherwise test the erasability of the marker of your choice in a small area before taking the plunge.

Low odor dry erase markers are also highly recommended for use in daycares and schools. Low odor markers may not erase as easily as regular “high odor” markers and may “ghost” more but the odor reduction is quite significant.

DO NOT use cloth type abrasive erasers, or rags, chalkboard eraser, wet eraser, and permanent Marker.

ERASING: To remove dry erase marker from the painted subtract, use either a microfiber cleaning cloth (wash cloths regularly and replace when no longer soft), dry erase board foam eraser and 3M whiteboard foam.

To prevent marker buildup on your whiteboard surfaces, occasionally clean with whiteboard cleaner.

Erasing Permanent marker pen :

1) Dip the Candy Whiteboard Eraser or 3M Whiteboard Eraser with some water and rub to the area with permanent marker. In case it is a stubborn stain, you can apply a little bit thinner on a white cloth (or thick hand tissue paper) and wipe it out.
Candy Whiteboard Paint (Dry Erase Paint) is resistant on any kind of solvent.

2) Use the non-alcohol Whiteboard Cleanser from E-Stationery Supplies